When the CNC machine fails, the current is detected by a tool such as an ammeter voltmeter.

Instrument measurement method Instrument measurement method refers to the detection of the machine tool by means of voltmeter, ammeter, oscilloscope, programmer, etc. when the CNC machine tool fails, and analyzes the position of the fault. When the CNC machine tool fails, you can first check whether the current, voltage, pulse, etc. are normal through tools such as ammeter voltmeter: If the position change fails, you can use the oscilloscope to detect the signal status of the measurement circuit, or detect whether there is a zero mark pulse, etc.: The programmable controller has failed. You can use the programmer to call up the interrupt stack and the block stack and find the fault according to its instructions.

Spare Parts Replacement The function of modern CNC machine tools is getting stronger and stronger, and the effect is getting better and better, but the result is that the scale of circuit integration is getting bigger and bigger and more complicated. When the CNC machine fails, it is difficult to discharge the fault in a short time, and even it is difficult to locate the fault in a small area. In this case, if you want to reduce the downtime, replacing the faulty module with the diagnostic spare part will be the most A way to be effective. If the spare parts are not diagnosed, they can be replaced with the same or compatible modules to make the system work properly.

The self-diagnosis function method has a strong self-diagnosis function in the control system of the CNC machine tool, which monitors the working state of the machine tool at any time. Once the CNC machine fails, the self-diagnostic system issues an alarm and indicates through the display what the cause of the failure may be. The self-diagnosis function of CNC machine tools is divided into hardware and software. If the hardware fails, it will not be able to alarm. Some CNC machine tools can make corresponding indications through different flashing frequencies or different combinations of LEDs to help find faults. The position of the board.

(Finish)

Skid Nitrogen Generator

Skid Nitrogen Generator is installed on one skid, it has compact structure, easy for ocean transportation, no need for site installation. When machine reach site, just need to put the machine on flat ground, connect power and gas pipeline, then one simple push on starting button makes the nitrogen generator begin to work. Its structure is as below:

From above drawing, it is clear that skid nitrogen generator has Air Compressor, air treatment part, air tank, nitrogen separator and nitrogen buffer tank. It has the following features:

Compact structure, easy installation;

Flow rate, purity adjustable;

Intelligent fully automatic operation;

Energy-saving operation;

Skid nitrogen generator photos

Skid Nitrogen Generator,Nitrogen Generator,Nitrogen Generation,Nitrogen Generation System

Shandong Gamma Gas Engineering Co. Ltd. , https://www.gammagases.com